Whirlpool Ice Maker Making Too Much Ice: A Comprehensive Guide
Whirlpool Ice Maker Making Too Much Ice: A Comprehensive Guide
Why Is My Whirlpool Ice Maker Making Too Much Ice?
If your Whirlpool ice maker is producing an excessive amount of ice, it can be a frustrating and costly problem. Fortunately, there are several common reasons why this may occur, and most can be easily resolved.
Common Causes of Excessive Ice Production
* Faulty Temperature Sensor
The temperature sensor in your ice maker is responsible for detecting the temperature of the ice bin. If the sensor is faulty, it may send incorrect signals to the ice maker, causing it to produce too much ice.
* Defective Ice Maker Control Board
The ice maker control board is the brains of the operation. It receives signals from the temperature sensor and other components and sends commands to the ice maker to produce ice. A defective control board can send incorrect commands, resulting in excessive ice production.
* Clogged Water Inlet Valve
The water inlet valve controls the flow of water into the ice maker. If the valve becomes clogged, it can restrict the flow of water, causing the ice maker to produce too much ice in an attempt to compensate.
* Oversized Ice Bin
If you have recently replaced your ice bin with a larger one, it may be causing your ice maker to produce too much ice. The larger bin will take longer to fill, and the ice maker may continue to produce ice even after the bin is full.
* Frequent Door Opening
If you frequently open the refrigerator door, warm air can enter the ice maker compartment. This can cause the ice maker to produce more ice in an attempt to keep the compartment cold.
Troubleshooting Your Whirlpool Ice Maker
If you suspect that your Whirlpool ice maker is making too much ice, there are several steps you can take to troubleshoot the problem:
1. Check the Temperature Sensor
Unplug the refrigerator and remove the ice maker. Locate the temperature sensor and use a multimeter to test its resistance. The resistance should be between 10 and 15 kilohms at room temperature. If the resistance is outside of this range, the sensor needs to be replaced.
2. Test the Ice Maker Control Board
Unplug the refrigerator and remove the ice maker. Locate the ice maker control board and use a multimeter to test the voltage at the terminals. The voltage should be between 12 and 15 volts. If the voltage is outside of this range, the control board needs to be replaced.
3. Clean the Water Inlet Valve
Unplug the refrigerator and turn off the water supply. Remove the water inlet valve and clean the screen with a soft brush. Reinstall the valve and turn on the water supply.
4. Adjust the Ice Maker Fill Time
The ice maker fill time is the amount of time that the ice maker fills the ice bin with water. If the fill time is too long, the ice maker will produce too much ice. To adjust the fill time, consult your Whirlpool ice maker user manual.
5. Limit Door Opening
Try to limit the number of times you open the refrigerator door. This will help to keep the ice maker compartment cold and reduce the amount of ice that is produced.
Solving Common Problems
Once you have identified the cause of the problem, you can take steps to solve it. Here are some common problems and their solutions:
* Faulty Temperature Sensor
Replace the faulty temperature sensor with a new one.
* Defective Ice Maker Control Board
Replace the defective ice maker control board with a new one.
* Clogged Water Inlet Valve
Clean the clogged water inlet valve or replace it with a new one.
* Oversized Ice Bin
Replace the oversized ice bin with a smaller one.
* Frequent Door Opening
Limit the number of times you open the refrigerator door.
Conclusion
If your Whirlpool ice maker is making too much ice, dont despair. By following the troubleshooting steps outlined in this article, you can identify and solve the problem quickly and easily.
