replacing a kenmore ice maker
#keyword: The Ultimate Guide to Replacing a Kenmore Ice Maker
What you need to do before you start
Replacing a Kenmore ice maker is a relatively simple task that can be completed in about an hour. Before you start, you will need to gather the following tools and materials:
* A new Kenmore ice maker
* A Phillips head screwdriver
* A flathead screwdriver
* A pair of pliers
* A bucket
* A wet/dry vacuum cleaner
Step-by-step instructions
1. Unplug the refrigerator. This is a safety precaution that will prevent you from being electrocuted.
2. Remove the front grille. The front grille is usually held in place by a few screws. Use a Phillips head screwdriver to remove the screws and then pull the grille off.
3. Locate the ice maker. The ice maker is usually located at the top of the freezer compartment. It is a white plastic box with a metal frame.
4. Disconnect the water line. The water line is connected to the ice maker with a plastic fitting. Use a pair of pliers to loosen the fitting and then pull the water line off.
5. Disconnect the electrical connector. The electrical connector is located on the back of the ice maker. Use a flathead screwdriver to release the connector and then pull it off.
6. Remove the ice maker. The ice maker is held in place by two screws. Use a Phillips head screwdriver to remove the screws and then pull the ice maker out.
7. Install the new ice maker. Insert the new ice maker into the opening and secure it with the two screws.
8. Reconnect the electrical connector. Push the electrical connector onto the back of the ice maker until it clicks into place.
9. Reconnect the water line. Push the water line onto the plastic fitting until it clicks into place.
10. Replace the front grille. Align the front grille with the opening and push it into place. Secure the grille with the screws.
11. Plug in the refrigerator. The ice maker will now start to make ice.
Tips
* If you are having trouble removing the front grille, you can try using a putty knife to pry it off.
* If you are having trouble disconnecting the water line, you can try using a pair of pliers to loosen the fitting.
* If you are having trouble removing the electrical connector, you can try using a flathead screwdriver to release the connector.
* If you are having trouble installing the new ice maker, you can try using a pair of pliers to hold the ice maker in place while you tighten the screws.
* If you are having trouble reconnecting the water line, you can try using a pair of pliers to push the water line onto the fitting.
* If you are having trouble reconnecting the electrical connector, you can try using a flathead screwdriver to push the connector onto the back of the ice maker.
Troubleshooting
If your Kenmore ice maker is not working, there are a few things you can check:
* Make sure that the refrigerator is plugged in.
* Make sure that the water line is connected to the ice maker.
* Make sure that the electrical connector is connected to the ice maker.
* Make sure that the ice maker is turned on.
* Make sure that the freezer compartment is cold enough.
If you have checked all of these things and your ice maker is still not working, you may need to call a qualified appliance repair technician.
Conclusion
Replacing a Kenmore ice maker is a relatively simple task that can be completed in about an hour. By following the steps in this guide, you can save yourself the cost of hiring a professional appliance repair technician.