Kenmore Elite 795 Ice Maker Replacement: A Comprehensive Guide
Kenmore Elite 795 Ice Maker Replacement: A Comprehensive Guide
Introduction
Is your Kenmore Elite 795 ice maker giving you trouble? Are you tired of running to the store for bags of ice? If so, it may be time to replace your ice maker.
Replacing an ice maker can be a daunting task, but its not as difficult as you might think. With the right tools and instructions, you can have your new ice maker up and running in no time.
In this blog post, we will provide you with a step-by-step guide on how to replace a Kenmore Elite 795 ice maker. We will also provide you with some tips on how to troubleshoot common ice maker problems.
Step-by-Step Guide to Replacing a Kenmore Elite 795 Ice Maker
1. **Gather your tools.** You will need the following tools to replace your ice maker:
* A Phillips head screwdriver
* A flat head screwdriver
* A pair of pliers
* A bucket
* A towel
2. **Disconnect the power.** Before you begin working on your ice maker, be sure to disconnect the power. You can do this by unplugging the ice maker from the outlet or by turning off the circuit breaker that powers the ice maker.
3. **Remove the old ice maker.** Once the power is disconnected, you can remove the old ice maker. To do this, follow these steps:
* Open the freezer door.
* Locate the screws that hold the ice maker in place.
* Remove the screws.
* Pull the ice maker straight out of the freezer.
4. **Install the new ice maker.** To install the new ice maker, follow these steps:
* Slide the new ice maker into the freezer.
* Line up the holes in the ice maker with the holes in the freezer.
* Insert the screws and tighten them.
* Plug the ice maker into the outlet.
5. **Turn on the power.** Once the new ice maker is installed, you can turn on the power. To do this, simply turn on the circuit breaker that powers the ice maker or plug the ice maker back into the outlet.
Troubleshooting Common Ice Maker Problems
If your ice maker is not working properly, there are a few things you can check.
* **Make sure that the power is connected.** The ice maker will not work if it is not connected to power.
* **Check the water supply.** The ice maker needs a constant supply of water to make ice. Make sure that the water supply line is connected to the ice maker and that the water valve is turned on.
* **Check the ice makers thermostat.** The thermostat controls the temperature of the ice maker. If the thermostat is set too high, the ice maker will not make ice. If the thermostat is set too low, the ice maker will make too much ice.
* **Check the ice makers timer.** The timer controls the cycle of the ice maker. If the timer is not working properly, the ice maker will not make ice.
Conclusion
Replacing a Kenmore Elite 795 ice maker is not a difficult task. With the right tools and instructions, you can have your new ice maker up and running in no time. If you are having problems with your ice maker, be sure to check the power, water supply, thermostat, and timer.
